Immobilizer Cleaner Tool software

Immobilizer reset software. This software has a database of immobilizer reset / clear of 947 different vehicle models. You just search in the database your model, select it and when you load the original immobilizer EEPROM file (read with an EEPROM programmer), it can be reset or cleaned, and in some models, totally eliminated if you wish to. The modified file is then re-written in the EEPROM chip and the ECM is ready to be used with, new, used or non-transponder keys.

This software will run on any x86 PC computer, but we recommend a minimum of Pentium II 133Mhz, running Windows 2000 / XP (Not tested on Windows Vista or Windows 7), 256 MB RAM, 40 MB Hard disk space and a monitor capable of a resolution of 1024x768 pixels.

For reading and writing the immobilizer EEPROM files you will be working with, you will need an EEPROM programmer and a special SMD clip for either programming it in-circuit or off-circuit. The EEPROM programmer can be any inexpensive type, able to accept serial EEPROMs like the 93c56, 93c66, 24c02, 25020, 25080, etc. and the clip is sold by the 3M Company and the Pomona Company, wit a cost of about $15. It is known as an SMD SOIC-8 clip and can be acquired at online electronic catalogs like Digikey.com.



You just take out the ECM from your vehicle, open it, locate the small 8-legged (pins) chip and reprogram it with the SOIC-8 SMD clip, using the already modified file selected. No soldering/desoldering needed. That is the purpose of using the SOIC-8 clip. This software is ideal for selling the service of clearing or resetting the immobilizer on the many supported vehicles



This is for downloading the Immo Tool 2 software for modifying the files of the supported 947 vehicles, general installation instructions and general software usage instructions. The programmer and clip are not included. Please note that this package is intended for technical experienced personnel only.

SMD SOIC-8 Clips, "Pomona" brand, can be obtained from Digikey.com in the link below. While the clip pictured in that link is for an SOIC-28, it is for representation purposes only, as the part number in that page is for the SOIC-8.

POMONA SOIC-8 SMD Clip

Because a wiring harness is needed to use the clip, you may construct your own. It is not difficult, but you may also obtain complete assembled kits from several sources, like the one shown below.

SOIC-8 Assembled Kit

Lastly, you will need a serial EEPROM programmer to read/write the EEPROM chips. While there are both expensive and non-expensive units available, what is really important is that such unit is able to work with the target device or devices (EEPROMs). Below are two examples of good programmers.

EETOOLS CHIPMAX PROGRAMMER

MCUMALL - PRO GQ-4X Willem Programmer

This is an INSTANT download. As soon as purchased, the download will be available from your account on this store.

NOTE:Although this is an instant download, this software requires a numeric license key for functioning.  When installed, it will self generate a "fingerprint" based on your hardware. This will be different in every computer and in every installation. You will need to email us that "fingerprint" that will be shown upon running the software for the first time. We will reply with your registration key on or before 24 hours. Most of the times, the waiting period is less than 1 or 2 hours. This process is only required once.